If you are looking for an engine rebuild or reconditioned engine look no further than jimmer at powerzed he has a great site, service and is a real master on these cars. He can take them apart and put them back together again with his eyes closed. Everything from changing the head gaskets to a full on performance rebuild. Check out his site www.powerzed.com for more information on engine rebuilds and replacement reconditioned engines.

These are the best looking wheels that you can put on a 300zx in my opinion, they were special order from Japan and took nearly 4 months to arrive. If you want to see them on the car have a look at the FINNISHED CAR!!! page on the top navigation.  I think that if you Read the rest of this entry »

Car lookas lovely, just need to send her off to get it running properly and do a few odd jobs... enjoy Read the rest of this entry »

At long last this 300zx gets its engine and gearbox fitted and its looking really good. After spending an afternoon checking that all the connections were done up four of us got a full day on the car to fit as much as we could. It was very interesting as we put the engine and Read the rest of this entry »

This is a nice fun job to do on the 300zx after you have deleted all the stuff that goes next to the brake servo. When you have done this there is enough room to put the resovoir on the bulkhead next to the wing. There is a bracket bolted on there with two 10mm Read the rest of this entry »

Now the thing is, when we got this car the original seats had already been removed and replaced with some Rage bucket seats.  Apart from that the original 90s tweed looked dated and in places the vinyl had started to lift and it looked tatty.  We have a great set of new front Recaros to Read the rest of this entry »

This is a dog of a job… I read a few places that a few people have done this with the engine in. Personally i would say this is impossible. They are either telling porkies or know something we dont, its a very difficult job to do and you will need to be very patient not Read the rest of this entry »

Ok well I have really struggled getting my head around all the bits on this car that you can actually throw away with a bit of effort. When we took the engine out we took lots of pictures and almost all the pipework has changed putting it back together. I will touch on a few Read the rest of this entry »

For the Audio we wanted to install a double din stereo and sat nav system. I wanted it to be a flush mount and to look like it has always been there. If you want to do this I have listed the instructions for doing it here. 1. Remove the metal retaining bracket from the Read the rest of this entry »

This job has taken James a few days to do but it will be well worth it.  Its a very slow job to do and critical to label and document the whole process. The fuse box wires were all cut then extended through a hole into the bulkhead then extended and re connected. Then some spacers were made to mount the fuse box in the front of the wheel arch just below the light. It is fairly accessible from either underneath the front bumper. Im not sure how possible this would be to do with the side mount intercoolers still in as we have put a front mount intercooler in.